IDK MSD-54 Series - Manual (Page 27)

27
7.4 Executing Control Commands
You can register up to nine control commands in MSD (COMMANDs A to I), but you can execute only five
commands (COMMANDs A to E) with control front panel command execution keys. To execute COMMANDs
F to I, perform “8.12.4 Command execution” or use RS-232C, LAN, or parallel input.
For COMMANDs A to I, nothing is registered by the factory default, so those keys will not work until their
commands are registered in “8.12.3 Command link”.
Command control: Controlling command execution: @EXC
To execute commands associated with Control Command execution keys (COMMANDs A to E):
■ Procedure
1
Select ”COMMAND” by the operation mode key.
2
Execute the registered command by the control command keys.
POWER
ON
OFF
DIGITAL MSD-5404
MULTI
SWITCHER
OUT1
OUT2
OUT3
OUT4
IN1 IN3 IN4 IN5 IN6 IN7 IN8 IN9 OFF POWER
DISPLAY
1
2
3
4
IN2
MENU/SET
ESC
COMMAND
E
COMMAND COMMAND COMMAND COMMAND
A B C D
V&A VIDEO AUDIO
SWITCHING MODE
PRESET LOAD
COMMAND
Control command keys
Operation mode key
[Figure 7.4] Keys for command execution