Msd-54 series user’s guide 98 – IDK MSD-54 Series User Manual
Page 98
MSD-54 SERIES User’s Guide
98
POWER
ON
OFF
DIGITAL
MSD-5404
MULTI
SWITCHER
OUT1
OUT2
OUT3
OUT4
IN1
IN3
IN4
IN5
IN6
IN7
IN8
IN9
OFF
POWER
DISPLAY
1
2
3
4
IN2
MENU/SET
ESC
COMMAND
E
COMMAND
COMMAND
COMMAND
COMMAND
A
B
C
D
V&A
VIDEO
AUDIO
SWITCHING MODE
PRESET LOAD
COMMAND
You can execute automatic measurement by pressing the input channel selection key for
2 seconds.
[Figure 8.39] Automatic measurement using input keys
Note:
The automatic measurement is available only if analog RGB or analog YPbPr
signals are input. If analog video signals are input, no signal is input, or video input
is set to a channel other than IN6 to IN9, you cannot execute the measurement
and the message shown right is displayed.
IN 1
IN 2
IN 3
IN 4
IN 5
IN 6
IN 7
IN 8
IN 9
N/A
N/A
N/A
N/A
N/A
A
A
A
A
A: Settable only if analog RGB/analog YPbPr signals are input.
N/A: Cannot be executed.
Since the automatic measurement is executed in the output side, the target input has to be first selected for
any of the output. If it is not selected for an output, the measurement cannot be executed.
2. To set the automatic measurement using commands:
@AIS: Automatic input measurement
@AIT: Automatic input measurement including aspect
[IN6 AUTO SETUP]
NOT AVAILABLE NOW