IDK MSD-54 Series - Manual (Page 141)

141
8.9.6 Speaker configuration [SPEAKER]
This menu is valid only all conditions below are met: if you select “INTERNAL EDID” for “8.9.1 EDID setting“,
you select a resolution other than “UNUSED” for ”8.9.3 HDTV resolutions”, and you connect an HDMI device
such as a Blu-ray recorder.
･The number of speakers: 1 to 8 [Default]: 2
If you select “AUTO” for the setting mode and set the number of speakers, the speaker configuration will be
set by default that is shown in the following table. To change the default configuration, set the mode to
“MANUAL” and set each speaker to ON/OFF individually.
[Table 8.9] Default speaker configuration
The
number of
speakers
FR/FL LFE FC RL/RR RC
FLC/
FRC
RLC/
RRC
FLW/
FRW
FLH/
FRH
TC FCH
1 OFF OFF ON OFF OFF OFF OFF OFF OFF OFF OFF
2 ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
3 ON ON OFF OFF OFF OFF OFF OFF OFF OFF OFF
4 ON ON ON OFF OFF OFF OFF OFF OFF OFF OFF
5 ON ON OFF ON OFF OFF OFF OFF OFF OFF OFF
6 ON ON ON ON OFF OFF OFF OFF OFF OFF OFF
7 ON ON ON ON ON OFF OFF OFF OFF OFF OFF
8 ON ON ON ON OFF OFF ON OFF OFF OFF OFF
REAR
FLH
FLW FL FLC FC
FCH
FRC
FRH
FR FRW
LFE
TC
RL RLC RC RRC RR
FRONT
FLH
FLW
FL
FLC
FC
FCH
FRC
FRH
FR
FRW
LFE
TC
RL
RLC
RC
RRC
RR
Front Left High
Front Left Wide
Front Left
Front Left Center
Front Center
Front Center High
Front Right Center
Front Right High
Front Right
Front Right Wide
Low Frequency Effect
Top Center
Rear Left
Rear Left Center
Rear Center
Rear Right Center
Rear Right
[Figure 8.45] Speaker configuration
For each input