IDK MSD-54 Series - Manual (Page 169)

169
[Step III. When setting “PORT” to CEC]
PORT:CEC
DELAY:
0 s000ms
▲▼keys: Set the delay time in seconds (0 to 999).
↓
◄►keys
PORT:CEC
DELAY: 0s00
0 ms
▲▼keys: Set the delay time in seconds in milliseconds (0 to 999).
↓
◄►keys
OUT1 CEC: -
▲▼keys: Select the control of OUT1 (-, POWER OFF, POWER ON).
↓
◄►keys
OUT2 CEC: -
▲▼keys: Select the control of OUT2 (-, POWER OFF, POWER ON).
↓
◄►keys
OUT3 CEC: -
▲▼keys: Select the control of OUT3 (-, POWER OFF, POWER ON).
↓
◄►keys
OUT4 CEC: -
▲▼keys: Select the control of OUT4 (-, POWER OFF, POWER ON).
↓
◄►keys
ERROR: S TOP
▲▼keys: Select the action for when retry over occurs (STOP, EXEC).
↓
◄►keys
MEMO:
1: ▲▼keys: Set the “MEMO” (20 to 7D of “9 ASCII codes” except for 2C).
◄►keys: Moves the cursor to the next character (Up to 14 characters).
↓ SET key: Applies settings.
[PRESET COMMAND 1]
NOW UPDATE... The message is displayed for one second and then previous screen is
displayed automatically.
↓
[COMMAND EDIT]
CMD
1
Note:
If you do not press the “SET” key, the control command is not changed. Make sure to press the “SET” key.
CEC can only control the power of display devices connected to the HDMI output connectors. Devices
connected to HDMI input connectors (IN1 to 5) cannot be controlled, and only power control is available.
This function may not work correctly in old devices and some devices supporting CEC.
2. To edit the control command using commands:
@SEC: Set control command (Control communication command)
@GEC: Get control command (Control communication command)
@SEC: Set control command (Display received data)
@GEC: Get control command (Display received data)
@SEC: Set control command (Control Tally output)
@GEC: Get control command (Control Tally output)
@SEC: Set control command (Control CEC)
@GEC: Get control command (Control CEC)