IDK MSD-54 Series User Manual
Page 250
MSD-54 SERIES User’s Guide
250
[Error code]
Displaying for each output connector: the output statuses of video and audio are
displayed on the lower right. The status characters are shown from the left to the
right, the statuses of video output to HDMI output connector, audio output to HDMI
output connector, and audio output to the analog audio output connector are displayed. The status of HDMI
output connector is displayed only if a display device is connected. If video or audio cannot be output, an error
code number or alphabet character is displayed.
[Table 8.38] Output status
Status
Video output
Audio output
If any number or “A” is not displayed, video or audio is output correctly.
1
－
“8.8.2 Output mute” is set to “ON”.
2
Displayed only for IN1 to IN5. DDC power supply is not input. (If no input device is connected, this
status is displayed.)
3
No video signal is input.
No audio signal is input
*1
4
Displayed only for IN1 to IN5. Video or audio output of source device is in a Mute status.
5
Displayed only for IN1 to IN5. Signals with HDCP are input, but the display device does not support
HDCP. (This may also be displayed while authenticating HDCP.)
6
Displayed only for IN1 to IN5. The source device does not output required information (packets) for
outputting video or audio.
7
Signals that are not supported by the MSD are
input. (Sampling clock is out of the range.)
Audio cannot be output, because
compressed audio is input. (Compressed
audio can be output only to display devices
supporting compressed audio.)
8
－
“8.8.8 Output connector“ is set to “OFF”.
9
－
“8.7.2 Output mode” is set to “DVI MODE” or
a display device that does not support audio
is connected.
*2
A
Input is set to “OFF”.
*1
Input status of analog audio signals cannot be detected. Even if this status is not displayed, audio may
sometimes not be output when analog input is selected.
*2
This status is only for HDMI output connectors.
2.
To display status of display device using commands:
@GSS: Get I/O status
[OUT1 MONITOR] H30
HDCP SUPPORT 333