IDK MSD-54 Series - Manual (Page 28)

MSD-54 SERIES User’s Guide
28
7.5 Loading Cross Point
You can register up to nine cross points in the MSD, but the MSD can only load cross points 1 to 5 by cross
point load keys. To load cross points 6 to 9, use menu settings in the “Load cross point” section (“8.13.1
Loading cross point”) or use RS-232C, LAN, or parallel inputs.
Since nothing is registered by factory default, cross point is not valid until they are registered. To load them,
register cross points in advance.
Command control:
▪ Loading V&A input selection setting from cross point memory: @RCM
▪ Loading video input selection setting from cross point memory: @RCV
▪ Loading audio input selection setting from cross point memory: @RCA
To load cross point settings:
■ Procedure
1
Select ”PRESET LOAD” using the Operation Mode selection key.
2
Press the cross point command keys to load the cross point settings.
Commands A to E correspond to cross points 1 to 5.
POWER
ON
OFF
DIGITAL MSD-5404
MULTI
SWITCHER
OUT1
OUT2
OUT3
OUT4
IN1 IN3 IN4 IN5 IN6 IN7 IN8 IN9 OFF POWER
DISPLAY
1
2
3
4
IN2
MENU/SET
ESC
COMMAND
E
COMMAND COMMAND COMMAND COMMAND
A B C D
V&A VIDEO AUDIO
SWITCHING MODE
PRESET LOAD
COMMAND
Cross point load key
Operation mode
selection keys
[Figure 7.5] Loading cross points
7.6 Locking/Unlocking Front Keys
To lock the front panel keys, press and hold the Operation Mode selection key for 2 seconds or longer until
hearing the buzzer sound. To release the key lock, do the same operation again. When the setting is changed,
the status will be displayed for 1 second.
KEY LOCK ! KEY LOCK RELEASE !
Command control: Setting and releasing key lock: @SLS/@GLS
Locked Unlocked