IDK MSD-54 Series - Manual (Page 110)

MSD-54 SERIES User’s Guide
110
8.7.5 Window transition effect [VIDEO SWITCHING]
You can select a window transition effect for when video inputs are switched.
Switching speed of effect other than “CUT” can be set in “8.7.6 Window transition ”.
[For MSD-5401/MSD-5402/MSD-5403/MSD-5404]
“CUT”: A black frame is displayed and the video input is switched instantly (approximately five frames).
“FADE OUT-IN”: The current video fades out slowly and then a black frame is displayed. After that, the next
video is displayed slowly.
“FREEZE->FADE OUT-IN”: The current video fades out slowly after a freeze.
“WIPE”: The color selected in ”8.7.7 Wipe color“ is wiped in and the video is displayed. After wipe-out, the
next video is displayed. You can select a wiping direction from four directions.
However, if you switch the channel from a channel without input video signals or switch it to a channel without
input video signals, “FADE OUT-IN” and WIPE OUT/IN cannot be performed regardless of the setting of this
menu. You can set the switching speed of “FADE OUT-IN” and WIPE OUT/IN by following “8.7.6 Window
transition ”.
･CUT
･FADE OUT-IN
･FREEZE→FADE OUT-IN [Default]
･LEFT→RIGHT WIPE
･RIGHT→LEFT WIPE
･TOP→BOTTOM WIPE
･BOTTOM→TOP WIPE
[For MSD-5401SL/MSD-5402SL]
“CUT”: The video input is switched instantly.
“DISSOLVE”: The current video is cross-fades and switched to the next video.
“FREEZE->DISSOLVE”: The current video is cross-faded after freeze.
“WIPE”: Video is wiped. You can select a wiping direction from four directions. If it is switched from or to a
channel without input video signals, the color selected in ”8.7.7 Wipe color“ is wiped in and the current video
disappears. After it is wiped out, the next video is displayed.
･CUT
･DISSOLVE
･FREEZE→DISSOLVE [Default]
･LEFT→RIGHT WIPE
･RIGHT→LEFT WIPE
･TOP→BOTTOM WIPE
･BOTTOM→TOP WIPE
Note:
The setting of this menu is valid not only when the input is switched, but also when “8.5.5 Automatic
detection of input video interruption” is set to “ON”.
For each output