IDK MSD-54 Series - Manual (Page 183)

183
* If you set “LINK” to “ON”, you can change all registered conditions at the same time.
2. To set the lighting condition of command keys using commands:
@STL: Set command ley lighting
@GTL: Get command ley lighting
8.12.8 Flash time (Command keys and DISPLAY POWER keys) [FLASH TIME]
You can set the flash time (blink duration) of command execution keys and power switch of display devices
during command execution:
You can set the time for COMMANDs A to I and DISPLAY POWER separately.
･Blinks while a control command is executed: EXECUTION
･Not blink: OFF
･Blinks for the set time*: 1 to 10000 sec.
[Defaults]: For COMMANDs A to I: OFF
For DISPLAY POWER: EXECUTION
* If the command execution has not been completed even after the set time passes, it continues to blink until
the execution is completed.
1. To set the flash time of command keys and display power keys using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
PRESET COMMAND
▲▼keys: Select “PRESET COMMAND”.
↓ SET key
[PRESET COMMAND]
FLASH TIME
▲▼keys: Select “FLASH TIME”.
↓ SET key
[COMMAND A]
O FF
▲▼keys: Set the flash time of COMMAND A
(EXECUTION, OFF, or 1 sec. to 1000 sec.).
↓▲▼keys
[COMMAND B]
O FF
▲▼keys: Set the flash time of COMMAND B
(EXECUTION, OFF, or 1 sec. to 1000 sec.).
▲▼keys
[DISPLAY4 POWER]
E XCUTION
▲▼keys: Set the flash time of DISPLAY POWER 4
(EXECUTION, OFF, or 1 sec. to 1000 sec.).
↓ ESC key: Returns to the previous screen.
2. To set the flash time of command keys and display power keys using menu:
@STF: Set flash time (Command keys and DISPLAY POWER keys)
@GTF: Get flash time (Command keys and DISPLAY POWER keys)