Wiring of the standard device – Lenze EVF9333−xV User Manual
Page 115
Advertising
Wiring of the standard device
Standard devices in the power range 0.37 ... 11 kW
Motor connection
5.4
5.4.6
l
5.4−13
EDSVF9333V EN 6.2−04/2012
PE
U V W
T1T2
U, V, W
T1, T2
0.5...0.6 Nm
4.4...5.3 lb-in
2
1
0
9300vec122
Fig. 5.4−8
Motor connection with KTY thermal sensor
0 Motor cable
1 Shield sheet
Clamp the motor cable shield with the straps. If required, fix by means of
cable tie.
2 U, V, W
Motor cable connection
Check the correct polarity. Observe maximum length of the motor cable. Use
wire end ferrules for flexible cables.
Max. connectable cable cross−section: 4 mm
2
, with pin−end connector
> 4 mm
2
Advertising
This manual is related to the following products: