Lenze EVF9333−xV - Manual (Page 366)

Configuration
Code table
8
8.5
l
8.5−18 EDSVF9333V EN 4.0−11/2007
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0168 Display of the fault messages in
the history buffer
l Keypad: LECOM error number
See System
Manual
(extension)
1 Fail no. act Active fault
2 Fail no. old1 Last fault
3 Fail no. old2 Second to last fault
4 Fail no. old3 Third last fault
5 Fail no. old4 Fourth−last fault
6 Fail no. old5 Fifth−last fault
7 Fail no. old6 Sixth−last fault
8 Fail no. old7 Last but six fault
C0169 Display in [s] Displays at what time the fault
(C0168) has occurred since mains
connection (C0179)
l If a fault is followed by another
fault for several times, only the
time of the last occurrence is
stored
1 Failtime act Active fault
2 Failtime old1 Last fault
3 Failtime old2 Second to last fault
4 Failtime old3 Third last fault
5 Failtime old4 Fourth−last fault
6 Failtime old5 Fifth−last fault
7 Failtime old6 Sixth−last fault
8 Failtime old7 Last but six fault
C0170 Displays how many times the
fault (C0168) has occurred after
the last mains connection
1 Counter act Active fault
2 Counter old1 Last fault
3 Counter old2 Second to last fault
4 Counter old3 Third last fault
5 Counter old4 Fourth−last fault
6 Counter old5 Fifth−last fault
7 Counter old6 Sixth−last fault
8 Counter old7 Last but six fault
C0173
s
UG limit 1 Adaptation of UG thresholds
Check during commissioning and
adapt, if necessary!
All controllers in the system must
have the same threshold! See System
Manual
(extension)
Mains LU OU
0 < 400 V 285 V 770 ... 755 V Device with or without brake
chopper
1 400 V 285 V 770 ... 755 V
2 460 V 328 V 770 ... 755 V
3 480 V 342 V 770 ... 755 V Device without brake chopper
4 480 V 342 V 800 ... 785 V Device with brake chopper
C0178 Op timer {s} Display only
Total time of the controller enable
(X5/28 = HIGH)
C0179 mainstimer {s} Display only
Total time of mains "ON"