Lenze EVF9333−xV - Manual (Page 362)

Configuration
Code table
8
8.5
l
8.5−14 EDSVF9333V EN 4.0−11/2007
IMPORTANT Possible settings Code
Selection Lenze Name No.
C0140
s
select direct 0 Search direction during flying
restart process
l Positive direction of rotation:
The motor rotates in CW
direction with view on the
motor shaft
l Negative direction of rotation:
The motor rotates in CCW
direction with view on the
motor shaft
^
8.2−25
^
8.2−48
0 NSET Only search in the direction of the
applied setpoint
1 inv. Nset Only search against the direction
of the applied setpoint
2 pos. Only search in positive direction of
rotation
3 neg. Only search in negative direction
of rotation
4 Both, Nset Search at first in the direction of
the applied setpoint and then
against the direction
5 Both, inv. Nset Search at first against the
direction and then in the direction
of the applied setpoint
6 Both pos. Search at first in positive then in
negative direction of rotation
7 Both neg. Search at first in negative then in
positive direction of rotation
C0141 FCODE (setval) 0.00 −199.9 {0.01 } 199.99 Main setpoint, freely configurable
code (FCODE)
l Used as main setpoint in the
basic configurations
C0005 = xxx1
C0142 Start options 1 Starting condition for the flying
restart circuit
^
8.2−36
^
8.2−65
0 Start lock l Automatic start is inhibited
after
– mains connection
– Cancel of a message
(t > 0.5 s)
– Trip reset
l Flying restart circuit is inactive
l Start after HIGH−LOW−HIGH
level change at X5/28
1 Auto start Automatic start when
X5/28 = HIGH
l Flying restart circuit is inactive
2 flying lock l Automatic start is inhibited
after
– mains connection
– Cancel of a message
(t > 0.5 s)
– Trip reset
l Flying restart circuit is active
l Start after HIGH−LOW−HIGH
level change at X5/28
3 Fly restart Automatic start when
X5/28 = HIGH
l Flying restart circuit is active