Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 16)

Summary of Changes
soc–i
Summary of Changes
The information below summarizes the changes to this manual since the last
printing as Publication 1761-6.2—October 1997.
To help you find new information and updated information in this release of
the manual, we have included change bars as shown to the right of this
paragraph.
The table below lists sections that document new features and additional
information about existing features, and shows where to find this new
information.
For This New Information See
Power supply inrush page 1–11
Class I, Division 2 certification pages 1–12, A–2
analog controllers pages 2–17, 7–1, 18–14, appendix A
automatic protocol switching page 3–13
DeviceNet communications page 3–13
software compatibility page 4–1
SCL instruction application example page 10–14
remote network support page D–17
Changes from the previous release of this manual that require you to
reference information differently are as follows:
•
The safety considerations for mounting your controller have been
updated; see chapter 1, Installing Your Controller.
•
The section on establishing communication has been updated; see chapter
3, Connecting the System.
•
For updated information on HHP support and compatibility of the series
functionality of your MicroLogix controller, see chapter 15, Using
Communication Protocols.
•
The message timing diagram has been updated; see chapter 15, Using
Communication Protocols.
•
The MicroLogix 1000 programmable controllers’ VA ratings and power
supply inrush specifications have been updated; see appendix A,
Hardware Reference.
•
The agency certification specifications have been updated; see appendix
A, Hardware Reference.
•
The analog output overall accuracy specification has been updated; see
appendix A, Hardware Reference.
•
The user interrupt latency information has been updated; see appendix B,
Programming Reference.
•
The DF1 Full-Duplex and DH-485 configuration parameters have been
updated; see appendix D, Understanding Communication Protocols.
New Information
Updated Information