Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 525)

MicroLogix
t 1000 with Hand-Held Programmer
Index
(HHP) User Manual
I–21
MCR, Master Control Reset, 12–6
memory module
clearing programs, 19–5
installation, 4–3
loading programs, 19–2
storing programs, 19–3
using, 19–1
Memory Pop (MPP), 8–10
entering the instruction, 8–12
execution times, 8–10
function code, 8–12
ladder representation, 8–10
using, 8–11
Memory Push (MPS), 8–10
entering the instruction, 8–10
execution times, 8–10
function code, 8–10
ladder representation, 8–10
using, 8–10
Memory Read (MRD), 8–10
entering the instruction, 8–11
execution times, 8–10
function code, 8–11
ladder representation, 8–10
using, 8–11
memory usage
listing, B–16
worksheet, B–21
menu
description, 4–8
how to complete tasks, 4–9
screen definition, 4–9
MEQ, Masked Comparison for Equal, 9–9
Message (MSG), 15–1
application examples, 15–12
control block layout, 15–3
entering parameters, 15–2
entering the instruction, 15–6
error codes, 15–11
execution times, 15–2
function code, 15–7
instruction parameters, C–7
ladder representation, 15–2
timing diagram, 15–9
using status bits, 15–4
valid addressing modes, C–7
valid file types, C–7
mnemonics, using
in instruction list programming, 6–15
in logical addresses, 6–8
mode
changing editing modes, 17–3
changing remote controller modes, 18–23
description, 4–10
how to complete tasks, 4–11
screen definition, 4–10
model for developing a logic program, 6–17
modems
dial-up phone , D–7
leased-line, D–8
line drivers, D–8
radio, D–8
using with MicroLogix controllers, D–7
modes of operation, 18–22
monitoring
data table files, 18–26
changing the radix, 18–30
operation, 5–9
fault recovery procedure, 20–11
of the controller, 18–25
of the data, 5–10
of the program, 5–9
program files, 18–25
motor starters (bulletin 509), surge
suppressors, 1–9
motor starters (bulletin 709), surge
suppressors, 1–9
mounting template, controller, A–7
mounting the controller
using a DIN rail, 1–13
using mounting screws, 1–14
MOV, Move, 11–15
Move (MOV), 11–15
entering parameters, 11–15
entering the instruction, 11–15
execution times, 11–15
function code, 11–15
instruction parameters, C–7
ladder representation, 11–15
updates to arithmetic status bits, 11–15
valid addressing modes, C–7
valid file types, C–7
move and logical instructions
And (AND), 11–18
Exclusive Or (XOR), 11–20
Masked Move (MVM), 11–16
Move (MOV), 11–15
Negate (NEG), 11–22
Not (NOT), 11–21
Or (OR), 11–19
overview, 11–13
changes to the math register, S13 and
S14, 11–14