Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 404)

Appendix B
Programming Reference
B–9
Each fault is classified as one of the following:
•
Non-User — A fault caused by various conditions that cease logic
program execution. The user-fault routine is not run when this fault
occurs.
•
Non-Recoverable — A fault caused by the user that cannot be recovered
from. The user-fault routine is run when this fault occurs. However, the
fault cannot be cleared.
•
Recoverable — A fault caused by the user that can be recovered from in
the user-fault routine by resetting major error halted bit (S1/13). The
user-fault routine is run when this fault occurs.
Refer to chapter 20 for more information regarding MicroLogix 1000 HHP
advisory messages.
Fault Classification
User
Address
Error
Code
(Hex)
Power up Errors Non-User
Non-
Recoverable
Recoverable
S6 0001
The default program was
loaded.
X
0002 Unexpected reset occurred. X
0003
EEPROM memory is
corrupt.
X
0008
A fatal internal programming
device error occurred.
X
0009
A fatal internal hardware
error occurred.
X
Fault Classification
User
Address
Error
Code
(Hex)
Going-to-Run (GTR)
Errors ➀
Non-User
Non-
Recoverable
Recoverable
S6 0005 Retentive data is lost. X
0010
The downloaded program is
not a controller program.
X
0016
Startup protection after
power loss, S:1/9 is set.
The user must check for a
retentive data lost condition
if the user-fault routine was
executed with startup
protection.
X
➀
Going-to-Run errors occur when the controller is going from any mode to REM Run mode or from any
non-Run mode (PRG, SUS) to Test mode.
Reference