Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 89)

Chapter 5
Quick Start for New Users
5–4
Reviewing What You’ve Done So Far
You have completed preparing to enter a new program with your HHP.
- ✔
Preparing to enter a new program
- ✔ Placing the controller in program mode
-
✔ Clearing the current program
-
Entering and running the program
- Entering the new program
- Changing to run mode
-
Monitoring operation
- Monitoring the program
- Monitoring the data
Continue on to the next section to enter and run a program.
You are now ready to create a program in file 2. Once the program is
entered, you will place the controller in run mode so you can monitor the
program.
Entering the New Program
The following rungs consist of LD, OR, ANI, and OUT instructions. You
will learn about these instructions in chapters 6 and 13. For now though, we
will use them to give you an idea of how to enter a simple program using the
MicroLogix 1000 HHP. The following diagram is the ladder representation
of what you will enter in the HHP.
| I I B |
|–+––] [–––+––––]/[––––––––––––––––––––––––––––––––––––( )––|
| | 6 | 7 0 |
| | | |
| | B | |
| +–––] [––+ |
| 0 |
| B O |
|––––] [––––––––––––––––––––––––––––––––––––––+–––( )–––––+–|
| 0 | 5 | |
| | | |
| | O | |
| +–––( )–––––+ |
| 1 |
Entering and Running the
Program