Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 353)

After You’ve Entered Your Program
Chapter 18
18–32
Changing Multi-Point Addresses
You can change an entry in the multi-point list by writing over the current
address. Follow the steps below.
1. Access the multi-point functional area.
+
MT PT -
B
I / 3 I 0 M P
– – – – – – – 0 0 1 0 0 0 1 0 0
2. Arrow to the address you want to write over.
3. Bring up a prompt to enter the address.
+
MT PT -
B
FUN
I / 3 I 0 M P
A D D R :
4. Enter the address of the new bit you want to monitor. B/0 is shown here
as an example:
ANB
0
ORB
+ - /
+
MT PT -
B
ENT
B / 0 B 0 M P
– – – – – – – 0 0 1 0 0 0 1 0 0
The new address is added to the multi-point list at the location you
selected in step 2.