Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) User Manual

Page 323

Advertising

After You’ve Entered Your Program

Chapter 18

18–2

You can change these default settings by accessing the program configuration
menu:

ENT

N A M E

P R O G

U S E R

P A S S W R D

Naming the Program

You can enter a new name for your program using any combination of the
letters or numbers available on the MicroLogix 1000 HHP keypad (i.e.,
A–F,I,N,O,R,S,T, and 0–9). The maximum length is eight characters.

Follow the steps below to change the program name.

1. Access the program configuration menu.

2. Select the first option,

NAME PROG

ENT

E N T E R

P R O G

N A M E :

3. Type in a new name for your program.

4. Enter the name and return to the previous functional area.

ENT

ESC

Your new program name is now displayed in the upper left-hand corner.

5. You must accept your program edits for this change to take affect. For

information on accepting edits, see page 18–21.

Setting the User and Master Passwords

Password protection prevents access to a program and prevents changes from
being made to the program. Each program may contain two passwords: the
user password and the master password. The master password overrides the
user password.

You can use passwords in the following combinations:

Advertising