Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 364)

Chapter 19
Common Procedures
19–5
Clearing a Program from a Memory Module
You can clear a program currently stored on a memory module by following
the steps below:
1. Go to the menu and choose the option MEM MODULE .
2. Select CLEAR PROGRAM .
C L E A R : P R O G R A M 1
P R O G R A M 2
A sub-menu appears listing the names of the programs contained on the
memory module. If there are no programs, dashed lines appear in place
of program names. In such a case, since there are no programs to clear,
you must press
ESC to exit the sub-menu.
3. Arrow down to the program you want to clear and select it.
n times
ENT
C L E A R P R O G R A M ?
P R O G R A M 3 : 0 0 2 K
A confirmation screen appears that shows the name of the program and its
size. If you do not want to clear this program, press
ESC to exit the
sub-menu.
4. Clear the program in the memory module.
ENT
C L E A R : P R O G R A M 3
C L E A R I N G . . .
Once the program is cleared from the module, you are returned to the
memory module sub-menu.