Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 368)

Chapter 19
Common Procedures
19–9
6. The DH-485 node address sub-menu appears next.
D H 4 8 5 N O D E 1 – 3 1
A D D R : 1
– To accept the default setting (1), press ENT .
– To change the default setting, delete the 1 by pressing DEL , type in the
new number, and then press ENT .
A P P L Y C O M M S
Y E S [ E N T ] N O [ E S C ]
7. Accept the communication settings.
ENT
A P P L Y I N G C O M M S
R E S E T T I N G U N I T
The MicroLogix 1000 HHP resets itself to the new communication settings
and runs through the power-up sequence.
Note: You cannot use the MicroLogix 1000 HHP to select or configure the
DF1 half-duplex slave protocol for Series D discrete or Series A
analog MicroLogix 1000 controllers.