Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 29)

Chapter 1
Installing Your Controller
1–13
!
ATTENTION: Be careful of metal chips when drilling
mounting holes for your controller. Drilled fragments that fall
into the controller could cause damage. Do not drill holes above
a mounted controller if the protective wrap is removed.
Use only the following communication cables in Class I, Division 2
Hazardous Locations.
Environment Classification Communication Cable
Class I, Division 2 Hazardous
ir e
1761-CBL-PM02 Series C ass I Di isi 2 a ar s
Environment
1761-CBL-HM02 Series C
1761-CBL-AM00 Series C
1761-CBL-AP00 Series C
2707-NC8 Series B
2707-NC9 Series B
2707-NC10 Series B
2707-NC11 Series B
Using a DIN Rail
Use 35 mm (1.38 in.) DIN rails, such as item number 199-DR1 or 1492-DR5
from Bulletin 1492.
To install your controller on the DIN rail:
1. Mount your DIN rail. (Make sure that the
placement of the controller on the DIN rail
meets the recommended spacing
requirements. Refer to controller
dimensions in appendix A.)
3. While pressing the controller against the
rail, snap the controller into position.
4. Leave the protective wrap attached until you
are finished wiring the controller.
2. Hook the top slot over the DIN rail.
20146
Side View
DIN
Rail
Protective Wrap
Mounting
Template
DIN
Rail
Call-out Dimension
A 84 mm (3.3 in.)
B 33 mm (1.3 in.)
C 16 mm (.63 in.)
A B
C