Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 336)

After You’ve Entered Your Program
Chapter 18
18–15
Selecting Channel Enable for the Analog Input Channels
This option allows you to enable/disable input channels 0–3 of the analog
controller.
To enable/disable the analog input channels:
1. Put the controller in RPRG mode (if it is not already in that mode).
2. Access the program configuration menu.
6 times
ENT
3. Arrow up to the option ANALOG CONFIG and select it.
2 times
ENT
Note: The function is only available when the Micro Term is attached to an
analog controller.
C H A N N E L E N A B L E
F I L T E R S E T T I N G
4. Enter to select the option CHANNEL ENABLE .
ENT
5. Arrow left or right to the setting you want for the displayed channel
(enabled or disabled) and select it.
6. Enter to store the selected setting and advance to the next channel screen.
ENT
7. Scroll up/down to move to the previous/next channel screen without
storing the setting.
8. Escape to return to the to the ANALOG CONFIG submenu without storing
the current setting.
ESC