Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 73)

Chapter 4
Using Your Hand-Held Programmer
4–6
When the MicroLogix 1000 HHP is first connected to the controller, the
following sequence occurs:
1. The HHP performs diagnostic self tests. While doing this it displays the
following Copyright screens:
M I C R O P R O G R A M M E R
V E R S I O N X . X X
A L L E N - B R A D L E Y C O
C O P Y R I G H T 1 9 9 4
A L L R I G H T S
R E S E R V E D
These screens will always appear in English, even if you later select an
alternate language for the HHP.
2. The HHP begins connecting to the controller and displays:
C O N N E C T I N G . . .
The HHP automatically finds the controller’s baud rate and connects to it
at that rate.
3. After a successful connection, the HHP displays the home screen.
For discrete controllers:
M I C R O R P R G
F R E E : 7 3 7 F I L E : 0 2
For analog controllers:
M I C R O R P R G
F R E E : 7 2 3 F I L E : 0 2
Important: If an error occurs during the power-up sequence, refer to
chapter 20, Troubleshooting, for a list of error codes.
Identifying the Power-Up
Sequence