Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 335)

After You’ve Entered Your Program
Chapter 18
18–14
Selecting the Filter Setting for Analog Input Channels
This option allows you to select the filter setting for the analog input
channels. The same setting is used for all four channels.
To change the filter setting for analog input channels:
1. Put the controller in RPRG mode (if it is not already in that mode).
2. Access the program configuration menu.
6 times
ENT
3. Arrow up to the option ANALOG CONFIG and select it.
2 times
ENT
Note: The function is only available when the Micro Term is attached to an
analog controller.
C H A N N E L E N A B L E
F I L T E R S E T T I N G
4. Arrow up to the option FILTER SETTING and select it.
2 times
ENT
Select a filter setting from the following list:
•
10 Hz
•
50 Hz
•
60 Hz
•
250 Hz
5. Scroll to the setting you want and select it.
6. Enter to store the filter setting and return to the ANALOG CONFIG
submenu.
ENT
7. Escape to return to the submenu without changing the filter setting.
ESC