Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 61)

Chapter 3
Connecting the System
3–8
Cable Selection Guide
1747-CP3
1761-CBL-AC00
Cable Length Connections from to AIC+
External
Power Supply
Required
➀
Power Selection Switch
Setting
➀
1747-CP3
1761 L 00
3m (9.8 ft)
c 17 7 i
SLC 5/03 or SLC 5/04 processor, channel 0 port 1 yes external 17 7 P3
1761-CBL-AC00
3 9 f
45 cm (17.7 in) PC COM port port 1 yes external
PanelView 550 through NULL modem adapter port 1 yes external
Port 1 on another AIC+ port 1 yes external
1761-CBL-AS03
1761-CBL-AS09
Cable Length Connections from to AIC+
External
Power Supply
Required
➀
Power Selection Switch
Setting
➀
1761-CBL-AS03
1761-CBL-AS09
3m (9.8 ft)
9.5m (31.17 ft)
SLC 500 Fixed,
SLC 5/01, SLC 5/02, and SLC 5/03 processors port 3 yes external
1761-CBL-AS09 9.5m (31.17 ft)
PanelView 550 RJ45 port port 3 yes external
1761-CBL-AM00
1761-CBL-HM02
Cable Length Connections from to AIC+
External
Power Supply
Required
Power Selection Switch
Setting
1761-CBL-AM00 45 cm (17.7 in)
2 6 f
MicroLogix 1000 port 2 no cable 1761 L M00
1761-CBL-HM02
➁
c 17 7 i
2m (6.5 ft) to port 2 on another AIC+ port 2 yes external
➀
External power supply required unless the AIC+ is powered by the device connected to port 2, then the
selection switch should be set to cable.
➁
Series B cables or higher are required for hardware handshaking.