Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 360)

19 Chapter
19–1
Common Procedures
Several of the menu items may be required after the control program has
been running. This chapter gives you details about these procedures and
other commonly performed tasks. The common procedures included here
are:
•
using a memory module
•
clearing a program from the micro controller
•
changing the micro controller’s baud rate
•
changing the micro controller’s communication defaults
You can use a memory module to store and retrieve programs. To use the
memory module, access the menu and choose the option
MEM MODULE .
4
MENU
I
ENT
L O A D P R O G R A M
S T O R E P R O G R A M
The options available for use with the memory module appear. You can
scroll through the options using the down arrow key. These options are:
•
load program (from the memory module to the controller)
•
store program (from the controller to the memory module)
•
clear program (in the memory module)
Each of these options is described in this section. For information on
installing and removing the memory module, see page 4–3.
!
ATTENTION: Always remove power from the HHP before
inserting or removing the memory module. This guards against
possible damage to the module, as well as undesired controller
faults.
Using a Memory Module