Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 352)

After You’ve Entered Your Program
Chapter 18
18–31
2. Arrow to the position you want to enter an address. This can be any open
point on the list.
3. Bring up a prompt to enter the address.
+
MT PT -
B
FUN
* * * * * M P
A D D R :
4. Enter the address of the bit you want to monitor. I/3 is shown here as an
example:
ENT
3
U
MENU
I
I / 3 I 0 M P
– – – – – – – – – – – – – – – 0
The address is added to the multi-point list at the location you selected in
step 2.
Automatically Entering Addresses
You can use short-cut keys to add a bit address to the multi-point list. Follow
the steps below.
1. While in either the program monitor or the data monitor, arrow to the bit
address you want to add to the multi-point list.
2. Add the address to the list.
+
MT PT -
B
FUN
The address is added to the next available open point in the multi-point
functional area.
Important: If the list is full, the message LIST FULL is displayed.
The address is not added to the multi-point list.
3. If you want to verify that the address was added, enter the multi-point
functional area.
+
MT PT -
B
Press ESC to return to the last screen.