Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 92)

Chapter 5
Quick Start for New Users
5–7
9. Add the final output instruction to the rung.
O
MODE
1 1
OUT
ENT
P 0 0 1
O / 1 0
10.Return to the home screen.
ESC
M I C R O R P R G
F R E E : * * * F I L E : 0 2
The RPRG is flashing because edits exist. Also, the number of free
instruction words is not known until the program is checked, so three
asterisks are displayed.
Changing to Run Mode
Now that you have entered a program, you can run it by changing to run
mode. Verify the mode by looking in the upper right-hand corner of the HHP
display. Right now it reads
RPRG (remote program mode). To change into
remote run mode, RRUN, follow these steps:
1. Access the mode options.
O
MODE
A C T I V E M O D E : R P R G
R P R G R R U N