Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 444)

E Appendix
E–1
Application Example Programs
This appendix is designed to illustrate various instructions described
previously in this manual. Application example programs include:
•
paper drilling machine using most of the software instructions
•
time-driven sequencer using TON and SQO instructions
•
event-driven sequencer using SQC and SQO instructions
•
bottle line example using the HSC instruction (up/down counter)
•
pick and place machine example using the HSC instruction (Quadrature
encoder with reset and hold)
•
RPM calculation using HSC, RTO, timer, and math instructions
•
on/off circuit using basic, program flow, and application specific
instructions
•
spray booth using bit shift and FIFO instructions
•
adjustable time delay example using timer instructions
Because of the variety of uses for this information, the user of and those
responsible for applying this information must satisfy themselves as to the
acceptability of each application and use of the program. In no event will
Allen-Bradley Company be responsible or liable for indirect or consequential
damages resulting from the use of application of this information.
The illustrations, charts, and examples shown in this appendix are intended
solely to illustrate the principles of the controller and some of the methods
used to apply them. Particularly because of the many requirements
associated with any particular installation, Allen-Bradley Company cannot
assume responsibility or liability for actual use based upon the illustrative
uses and applications.