Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 363)

Chapter 19
Common Procedures
19–4
If you do not want to write over the existing program, press ESC to exit the
sub-menu. Then if you still want to store the program that is currently
loaded in the controller to a memory module, do one of the following:
•
Go to the program configuration menu and rename the current program
(see page 18–2). Then store the program to the memory module under its
new name.
•
Replace the memory module that is currently in the MicroLogix 1000
HHP with one that does not have a program with this name. Then store
the program to that memory module.
!
ATTENTION: Always remove power from the HHP before
inserting or removing the memory module. This guards against
possible damage to the module, as well as undesired controller
faults.
If a MEM MOD FULL Message Appears
If the module does not have sufficient memory to store the program, the
message
MEM MOD FULL appears. Press any key to remove the message.
You are then returned to the memory module options screen.
If you still want to store the program that is currently loaded in the controller
to a memory module, do one of the following:
•
Clear a program(s) from the memory module to make room for the
program that is currently loaded. (See the next section.) Then try storing
the program to the memory module again.
•
Replace the memory module that is currently in the MicroLogix 1000
HHP with one that has more memory available. Then store the program
to that memory module.
!
ATTENTION: Always remove power from the HHP before
inserting or removing the memory module. This guards against
possible damage to the module, as well as undesired controller
faults.