Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 78)

Address
Instruction
Controller/
Edit Mode
Force Indication
Data Value
Rung
Number
Chapter 4
Using Your Hand-Held Programmer
4–11
How to Complete Tasks
You complete tasks by pressing the appropriate key or key sequence from
the mode screen.
To: Press:
scroll left or right between the controller mode
options
choose the controller option that is currently
highlighted
ENT
return to the previous screen ESC
Program Monitor
From the program monitor functional area you can create, view, edit,
and troubleshoot your controller programs.
Screen Definition
The following figure shows a typical screen for a bit instruction and
identifies its main sections.
P 0 0 0 / F O x
I / 7 0
Section Description
Controller/Edit Mode
The current mode of the controller is displayed in
abbreviated form, where P=RPRG, R=RRUN, T=RCSN
or RSSN, S=RSUS, and F=FLT. If the controller is in
RPRG you can utilize the editing modes as well, where
P=append and O=overwrite. The mode will flash when
edits exist.
Rung Number The rung number currently being viewed is displayed.
Instruction The instruction currently being viewed is displayed.
Address The address currently being viewed.
Force Indication
Indicates that the bit currently being viewed is being
forced.
x=N if forced on, and x=F if forced off. If no force exists,
this field is blank.
Data Value The data value of the address is shown here.
Mode
Access Program
Monitor by pressing
these keys:
MON ENT