Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 86)

5 Chapter
5–1
Quick Start for New Users
This chapter can help you get started using the MicroLogix 1000 HHP with
your micro controller. It provides task-oriented procedures to guide you
through a hands-on practice exercise.
Before you begin you should have completed the following tasks:
- ✔ Your controller should be installed and wired. (See chapters 1 and 2.)
-
✔ Your HHP should be connected and powered-up. (See chapters 3 and 5.)
Here’s what you’ll be doing to get started with the MicroLogix 1000 HHP:
-
Preparing to enter a new program
- Placing the controller in program mode
- Clearing the current program
-
Entering and running the program
- Entering the new program
- Changing to run mode
-
Monitoring operation
- Monitoring the program
- Monitoring the data
Once you’ve finished these steps you will have a good idea of what it takes
to program your micro controller with a MicroLogix 1000 HHP. You will
also know how to execute and monitor program activity.
If You’d Like More Examples
Be sure you read the last section in this chapter. It directs you to more
examples throughout the manual.
What to Do First