Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 87)

Chapter 5
Quick Start for New Users
5–2
Before you can enter a new program, you must complete the two preliminary
procedures described in this section.
Placing the Controller in Program Mode
If the controller is not currently in program mode, you need to change to that
mode. Follow the steps below:
1. From the home screen, access the mode options.
O
MODE
A C T I V E M O D E : R R U N
R P R G R R U N
2. Select RPRG mode. (The RPRG mode box is already highlighted.)
ENT
Once the controller enters the program mode, you are returned to the
home screen.
Clearing the Current Program
Clear the current program from the controller by following these steps:
1. Access the menu screen.
MENU
I
1 . L A N G U A G E
2 . A C C E P T E D I T S
Preparing to Enter a New
Program