Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 354)

After You’ve Entered Your Program
Chapter 18
18–33
Removing Multi-Point Addresses
You can remove individual addresses from the multi-point list or you can
delete the entire list.
Deleting Individual Addresses
Follow these steps to delete a single bit address from the multi-point list:
1. Access the multi-point functional area.
+
MT PT -
B
I / 3 I 0 M P
– – – – – – – 0 0 1 0 0 0 1 0 0
2. Arrow to the address you want to delete.
3. Remove the address from the list.
DEL
A L L
A dashed line replaces the bit data, indicating that this is now an open
point on the list.
Deleting All Addresses
Follow these steps to remove all of the addresses currently entered in the
multi-point list:
1. Access the multi-point functional area.
+
MT PT -
B
I / 3 I 0 M P
– – – – – – – 0 0 1 0 0 0 1 0 0
2. From any location in the list, press the delete all key sequence.
DEL
A L L
FUN
C L E A R L I S T ?
Y E S [ E N T ] N O [ E S C ]