Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 519)

MicroLogix
t 1000 with Hand-Held Programmer
Index
(HHP) User Manual
I–15
worksheet, B–21
extended I/O configuration bit, setting, 18–8
F
fault messages, 20–13
fault override bit, setting, 18–7
fault recovery procedure, 20–11, 20–12
fault routine, 20–12
FFL, FIFO Load, 11–25
FFU, FIFO Unload, 11–25
FIFO and LIFO instructions
FIFO Load (FFL), 11–25
FIFO Unload (FFU), 11–25
LIFO Load (LFL), 11–28
LIFO Unload (LFU), 11–28
overview, 11–23
effects on index register S24, 11–24
entering parameters, 11–23
entering the instructions, 11–24
FIFO Load (FFL), 11–25
entering the instruction, 11–25
execution times, 11–25
function code, 11–25
instruction parameters, C–4
ladder representation, 11–25, 11–28
operation, 11–26
valid addressing modes, C–4
valid file types, C–4
FIFO Unload (FFU), 11–25
entering the instruction, 11–26
execution times, 11–25
function code, 11–26
instruction parameters, C–4
ladder representation, 11–25, 11–28
operation, 11–26
valid addressing modes, C–4
valid file types, C–4
file indicator (#), 6–10
file organization
compared to the programming software’s
file organization, 6–3
data files, 6–4
program, 6–3
program files, 6–4
file types, C–1, F–1
Fill File (FLL), 11–10
entering parameters, 11–12
entering the instruction, 11–12
execution times, 11–10
function code, 11–13
instruction parameters, C–5
ladder representation, 11–10
using, 11–12
valid addressing modes, C–5
valid file types, C–5
First Instruction on Rung screen, 17–2
FLL, Fill File, 11–10
forcing inputs and outputs, 18–35
forcing external input data file bits, 18–35
guide to forcing, 18–37
forcing external output circuits, 18–38
guide to forcing, 18–39
FRD, Convert from BCD, 11–3
function codes, listing, B–13
functional areas, HHP, 4–7
data monitor, 4–13
home, 4–7
menu, 4–8
mode, 4–10
multi-point function, 4–15
program monitor, 4–11
G
general editing keys, identifying, 4–4
general specifications, A–2
controller, A–2
HHP, A–9
GEQ, Greater Than or Equal, 9–8
getting started, 5–1
entering and running the program, 5–4
monitoring operation, 5–9
preparing to enter a new program, 5–2
what to do first, 5–1
what to do next, 5–12
Greater Than (GRT), 9–7
AND GRT
entering the instruction, 9–7
execution times, 9–7
function code, 9–7
instruction parameters, C–5
ladder representation, 9–7
valid addressing modes, C–5
valid file types, C–5
LD GRT
entering the instruction, 9–7
execution times, 9–7
function code, 9–7
instruction parameters, C–5
ladder representation, 9–7
valid addressing modes, C–5