Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) User Manual
Page 34
Chapter 2
Wiring Your Controller
2–4
Call-out
Dimension
C
6.35 mm (0.250 in.)
E
10.95 mm (0.431 in.) maximum
L
14.63 mm (0.576 in.) maximum
W
6.35 mm (0.250 in.)
X
3.56 mm (0.140 in.)
C+X
9.91 mm (0.390 in.) maximum
We recommend using either of the following AMP spade
lugs: part number 53120-1, if using 22–16 AWG, or part
number 53123-1, if using 16–14 AWG.
Important: If you use wires without lugs, make sure the wires are
securely captured by the pressure plate. This is
particularly important at the four end terminal positions
where the pressure plate does not touch the outside wall.
20148i
!
ATTENTION: Be careful when stripping wires. Wire
fragments that fall into the controller could cause damage. Do
not strip wires above a mounted controller if the protective wrap
is removed.
Protective
Wrap (remove after wiring)
!
ATTENTION: Remove the protective wrap before applying
power to the controller. Failure to remove the wrap may cause
the controller to overheat.