Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) User Manual
Page 425
Appendix C
Valid Addressing Modes and File Types
for Instruction Parameters
C–9
Instruction
Valid Value
Ranges
Valid File Types
Valid Addressing
Mode(s)
Instruction
Parameter
Description
SCL
Scale Data
source
direct, indexed direct
O, I, S, B, T, C, R, N
Not Applicable
rate
immediate, direct,
indexed direct
O, I, S, B, T, C, R, N
–32,768–32,767
offset
immediate, direct,
indexed direct
O, I, S, B, T, C, R, N
–32,768–32,767
destination
direct, indexed direct
O, I, S, B, T, C, R, N
Not Applicable
SET
Set (or Output Latch)
bit address
direct
O, I, S, B, T, C, R, N
Not Applicable
SQC
Sequencer Compare
file
indexed direct
O, I, S, B, N
Not Applicable
mask
immediate, direct,
indexed direct➀
O, I, S, B, T, C, R, N
–32,768–32,767
source
direct, indexed direct➀
O, I, S, B, T, C, R, N
Not Applicable
control
direct
R (element level)
Not Applicable
length
(contained in the
control register)
1–255
position
(contained in the
control register)
0–255
SQL
Sequencer Load
file
indexed direct
O, I, S, B, N
Not Applicable
source
direct, indexed direct➀
O, I, S, B, T, C, R, N
–32,768–32,767
control
direct
R (element level)
Not Applicable
length
(contained in the
control register)
1–255
position
(contained in the
control register)
0–255
SQO
Sequencer Output
file
indexed direct
O, I, S, B, N
Not Applicable
mask
direct, indexed direct➀
O, I, S, B, T, C, R, N
–32,768–32,767
destination
direct, indexed direct➀
O, I, S, B, T, C, R, N
Not Applicable
control
direct
R (element level)
Not Applicable
length
1–255
position
0–255
SQR
Square Root
source
immediate, direct,
indexed direct
O, I, S, B, T, C, R, N
–32,768–32,767
f-min–f-max
destination
direct, indexed direct
O, I, S, B, T, C, R, N
Not Applicable
STD
Selectable Timed
Disable
Not Applicable
STE
Selectable Timed
Enable
Not Applicable
➀ Indexed addressing is not allowed when using T, C, or R addresses.