Chapter 2 wiring your controller – Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) User Manual
Page 36
Chapter 2
Wiring Your Controller
2–6
The following pages show the wiring diagrams, discrete input voltage ranges
and discrete output voltage ranges. Controllers with dc inputs can be wired
as either sinking or sourcing configurations. (Sinking and sourcing does not
apply to ac inputs.)
Important:
This symbol denotes a functional earth ground terminal
which provides a low impedance path between electrical circuits
and earth for non-safety purposes, such as noise immunity
improvement.
!
ATTENTION: The 24V dc sensor power source should not be
used to power output circuits. It should only be used to power
input devices (e.g. sensors, switches). Refer to page 1–3 for
information on MCR wiring in output circuits.
1761-L16AWA Wiring Diagram
NOT
USED
NOT
USED
79–132V ac
L2/N
L1
VAC
VDC
O/0
VAC
VDC
O/1
VAC
VDC
O/2
O/3
VAC
VDC
O/4
L2/N
O/5
85–264 VAC
CR
CR
I/9
I/0
I/1
I/2
I/3
I/4
I/5
I/6
I/7
I/8
AC
COM
AC
COM
L1
CR
L2/N
L1
VAC 1
VAC 1
COM
VAC 2
VAC 2
COM
VDC 1
VDC 1
COM
VDC 2
VDC 3
COM
79–132V ac
VAC
VDC
CR
VDC 2
COM
VDC 3
1761-L16AWA Input Voltage Range
0V ac
20V ac
132V ac
79V ac
ЙЙЙЙЙЙЙЙЙЙЙЙЙ
ЙЙЙЙЙЙЙЙЙЙЙЙЙ
On
?
Off
1761-L16AWA Output Voltage Range
0V dc
125V dc
5V dc
ЙЙЙ
ЙЙЙ
0V ac
264V ac
5V ac
?
Operating Range
Wiring Diagrams, Discrete
Input and Output Voltage
Ranges