Rockwell Automation 1761-HHP-B30 MicroLogix 1000 with Hand-Held Programmer (HHP) - Manual (Page 194)

Chapter 11
Using Data Handling Instructions
11–11
All elements are copied from the source file into the destination file each
time the instruction is executed. Elements are copied in ascending order.
If your destination file type is a timer, counter, or control file, be sure that the
destination words corresponding to the status elements of your source file
contain zeros.
Entering the Instruction
You enter the instruction from within the program monitor functional area.
The following items apply when entering the instruction:
•
Whenever you see asterisks on the display, the HHP is waiting for data
entry (i.e., a number).
•
You can return to previously entered operands by pressing this key:
Then if you want to edit that operand, press DEL or FUN-DEL and enter
new parameters. Press ENT to accept the operand and move on to the next
one. Once the entire instruction is entered, if you want to edit the
instruction’s parameters, you must go into the overwrite mode. (See page
17–4.)
P 0 0 0 C O P S R C
# C 1 1 0 0 0 0 H
P 0 0 0 C O P D E S T
# N 1 4 0
P 0 0 0 C O P L E N
2 5
4
ENT
ANB
0 1
FUN
To enter the function code, press: