Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 107)

Configuring a Network 10-1
C
HAPTER
10
Configuring a Network
You can have a DeviceNet Interface board, AutoMax Network Communication board,
or ControlNet Network Communication board installed in the drive. This chapter
describes the parameters that you can configure for these networks. For information
on the networks, see the appropriate network manual.
Some parameters are only accessible over the network using the alternate register
map (
NETW REGISTER MAP SEL (P.914) set to ALTERNATE ).
Refer to the appropriate option board instruction manual for more information.