Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 171)

C-9
METER OUT 2 SELECT (P.405) • CML FEEDBACK (P.397)
• CML REFERENCE (P.396)
• CML ERROR (P.398)
• SPD LOOP FEEDBACK (P.296)
• SPD LOOP REFERENCE (P.295)
• SPD LOOP ERROR (P.297)
• SPD LOOP OUTPUT (P.299)
• SPEED RAMP OUTPUT (P.199)
• SPEED RAMP INPUT TP (P.198)
• SPD SOURCE SELECT OUT (P.193)
• TRIM OUTPUT (P.197)
• ARMATURE VOLTAGE (P.289)
• ANALOG TACH FEEDBACK (P.291)
• PULSE TACH FEEDBACK (P.292)
• ZERO
• FULL SCALE
• POWER OUTPUT
• OCL REFERENCE (P.845)
• OCL RAMP OUTPUT (P.846)
• OCL FEEDBACK (P.847)
• OCL OUTPUT (P.848)
• FIELD REFERENCE (P.590)
• FIELD FEEDBACK (P.589)
• NETW IN REG 1 (P.905)
• NETW IN REG 2 (P.906)
• NETW IN REG 3 (P.907)
SPD LOOP
FEEDBACK
METER OUT 2 ZERO ADJ (P.403) –200 to 200 0
MINIMUM SPEED (P.003) 0 to MAXIMUM SPEED ( RPM or user-
defined units)
250 RPM
MOP ACCEL TIME (P.115) ACCELERATION TIME to 300.0 seconds 5.0 seconds
MOP DECEL TIME (P.120) DECELERATION TIME to 300.0 seconds 5.0 seconds
MOP RESET ENABLE (P.116) • OFF
• ON
OFF
MOTOR HOT FLD AMPS (P.510) 0.11 to installed supply rating (4.00,
10.00, or 20.00 amps) 0.01 amps
MOTOR RATED ARM AMPS (P.008) 0 to 3000.0 amps 8.0 amps
MOTOR RATED ARM VOLTS (P.009) 160 to 675 volts 240 volts
Table C.1 – Parameter Settings Quick Reference Table (Continued)
Parameter
Parameter Selection/
Adjustment Range
Initial Factory
Setting (Default)
Your Data
Date Setting