Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 165)

C-3
ANLG OUT 2 SELECT (P.421) • CML FEEDBACK (P.397)
• CML REFERENCE (P.396)
• CML ERROR (P.398)
• SPD LOOP FEEDBACK (P.296)
• SPD LOOP REFERENCE (P.295)
• SPD LOOP ERROR (P.297)
• SPD LOOP OUTPUT (P.299)
• SPEED RAMP OUTPUT (P.199)
• SPEED RAMP INPUT TP (P.198)
• SPD SOURCE SELECT OUT (P.193)
• TRIM OUTPUT (P.197)
• ARMATURE VOLTAGE (P.289)
• ANALOG TACH FEEDBACK (P.291)
• PULSE TACH FEEDBACK (P.292)
• ZERO
• FULL SCALE
• POWER OUTPUT
• OCL REFERENCE (P.845)
• OCL RAMP OUTPUT (P.846)
• OCL FEEDBACK (P.847)
• OCL OUTPUT (P.848)
• FIELD REFERENCE (P.590)
• FIELD FEEDBACK (P.589)
• NETW IN REG 1 (P.905)
• NETW IN REG 2 (P.906)
• NETW IN REG 3 (P.907)
ZERO
ANLG TACH VOLTS /1000 (P.203) 18.0 to 200.0 VOLTS /1000 RPM 18.0 VOLTS /1000
RPM
ARM VOLTAGE GAIN ADJ (P.204) 0.750 to 1.250 1.000
ARM VOLTAGE ZERO ADJ (P.205) –200 to 200 0
AUTO MODE MIN BYPASS (P.111) • OFF
• ON
OFF
AUTO MODE RAMP BYPASS (P.112) • OFF
• ON
OFF
AUTO REFERENCE SELECT (P.103) • ANALOG
• FREQUENCY IN
ANALOG
CML FEEDBACK GAIN ADJ (P.300) 0.900 to 1.100 1.000
CML PI LEAD FREQUENCY (P.302) 10 to 500 RAD / S 100 RAD / S
Table C.1 – Parameter Settings Quick Reference Table (Continued)
Parameter
Parameter Selection/
Adjustment Range
Initial Factory
Setting (Default)
Your Data
Date Setting