Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 11)

Introduction 1-1
C
HAPTER
1
Introduction
1.1 Before You Start
This manual assumes that the hardware has already been installed. See the
FlexPak 3000 drive hardware manual, D2-3404, for detail.
Important: Before operating the drive, you must perform Quick Start and the
self-tuning procedure, described in the OIM manual. Quick Start lets you
configure the most commonly used parameters through one menu and
includes self-tuning. This helps you set up the drive as quickly as
possible.
See the OIM manual for information on configuring parameters and using Quick Start.
1.2 Where to Find Information
This manual describes the software of the FlexPak 3000 drive DC drive. It does not
describe hardware or the operator interface. To find information on:
• Hardware, including installation and wiring information: See D2-3404,
FlexPak 3000 DC Drive Hardware Reference.
• The Operator Interface Module ( OIM ), including setting parameters, saving
parameters, and using Quick Start: See D2-3344, FlexPak 3000 Drive Operator
Interface Module (
OIM ) User Guide.
• Kits: See the instruction manual supplied with the kit.
This manual groups parameters by function. To find a specific parameter, see the
index or Appendix D, Numeric Parameter List, for a list of parameters with their page
numbers.
As you change parameter values, you can record them using the table in Appendix C,
Parameter Settings Record.
1.3 Conventions
Parameter names: In most instances, parameter names are shown as the parameter
name followed by the parameter number. For example:
ACCELERATION TIME (P.001).
For text parameter options, the options are shown in all caps. For example: TERMBLK .