Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 42)

4-22 FlexPak 3000 DC Drive Software Reference
SPD SOURCE SELECT OUT (P.193)
The selected speed
reference source
value in
RPM or the
units you defined. It is
an input to the speed
reference ramp
section.
Parameter Range: n/a
Default Setting: n/a
Parameter Type: Output
OIM Menu Path(s): Drive Reference - Drive Reference Test Points
SPEED RAMP INPUT TP (P.198)
The value of the
speed reference
signal immediately
before the speed loop
S-curve block. Parameter Range: n/a
Default Setting: n/a
Parameter Type: Output
OIM Menu Path(s): Drive Reference – Drive Reference Test Points
SPEED RAMP OUTPUT (P.199)
The value of the
speed reference
signal immediately
after the speed loop
S-curve block. Parameter Range: n/a
Default Setting: n/a
Parameter Type: Output
OIM Menu Path(s): Drive Reference – Drive Reference Test Points
STOP DECEL SELECT
(P.122)
Selects which
deceleration time will
be used for ramp stop
sequences,
DECELERATION TIME
(P.002) or RAMP STOP
DECEL TIME (P.018).
Parameter Range: 1 = DECELERATION TIME
2 = RAMP STOP DECEL TIME
Default Setting: 1
Parameter Type: Configurable
OIM Menu Path(s): Additional Parameters (listed by parameter number)
This only affects ramp stop times. Speed changes when the drive is running use
DECELERATION TIME regardless of the STOP DECEL SELECT choice.