Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 81)

Configuring the Metering Outputs 7-1
C
HAPTER
7
Configuring the Metering Outputs
The FlexPak 3000 drive offers two filtered outputs that can be used to source external
meters. These outputs are at terminals 24 through 26 on the Regulator board. See the
hardware manual for information on wiring these outputs.
These outputs can be modified by the parameters described in this chapter.
Figure 7.1 – Metering Outputs Block Diagram
From Figure 6.2, Current Minor
Loop Block Diagram
From Figure 5.1, Speed Loop
Block Diagram
From Figure 4.5, Speed Reference
Ramp Block Diagram
From Figure 4.2, Speed Reference Source
Select Block Diagram
From Figure 9.1, Outer Control Loop Block Diagram
From Figure 8.1, Field Block DIagram if Field
Current Regulator Kit is Installed
From Figure 5.1, Speed Loop Block Diagram
From Figure 4.5, Speed Reference Ramp Block Diagram