Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 179)

D-1
A
PPENDIX
D
Numeric Parameter List
This list is provided as a convenience for finding specific parameter descriptions. For an alphabetic listing, see
the index.
Table D.1 – Numeric List of Parameters
Number Name Page
000 CONTROL SOURCE 3-1
001 ACCELERATION TIME 4-18
002 DECELERATION TIME 4-19
003 MINIMUM SPEED 4-20
004 MAXIMUM SPEED 4-20
005 POSITIVE CURRENT LIM 5-17
006 NEGATIVE CURRENT LIM 5-16
007 MAXIMUM CURRENT 6-2
008 MOTOR RATED ARM AMPS 6-8
009 MOTOR RATED ARM VOLTS 5-5
010 CT TURNS RATIO 6-8
011 TOP SPEED 4-24
012 JOG SPEED 1 4-27
013 JOG ACCEL / DECEL TIME 4-26
014 S - CURVE ROUNDING 4-21
015 REVERSE DISABLE 4-21
017 JOG SPEED 2 4-27
018 RAMP STOP DECEL TIME 4-20
019 SPD LOOP SCAN TIME 5-2
100 ANLG AUTO SIGNAL TYPE 4-5
101 ANLG AUTO GAIN ADJ 4-5
102 ANLG AUTO ZERO ADJ 4-5
103 AUTO REFERENCE SELECT 4-6
104 ANLG MAN REF GAIN ADJ 4-7
105 ANLG MAN REF ZERO ADJ 4-7
106 MANUAL REF SELECT 4-7
107 TRIM REF REGISTER 4-15
108 TRIM REFERENCE SELECT 4-16
109 TRIM RANGE 4-15
110 TRIM MODE SELECT 4-14
111 AUTO MODE MIN BYPASS 4-18
112 AUTO MODE RAMP BYPASS 4-19
113 STOP SPEED THRESHOLD 4-23
114 STOP MODE SELECT 4-23
115 MOP ACCEL TIME 4-10
116 MOP RESET ENABLE 4-10
117 PRESET SPEED 1 4-12
118 PRESET SPEED 2 4-12
119 PRESET SPEED 3 4-12
120 MOP DECEL TIME 4-10
121 JOG OFF DELAY TIME 4-27
122 STOP DECEL SELECT 4-22
188 ANALOG AUTO REFERENCE 4-4
189 TORQUE REFERENCE 6-5
191 MOP OUTPUT 4-10
192 ANALOG MAN REFERENCE 4-6
193 SPD SOURCE SELECT OUT 4-22
194 ANALOG MAN TRIM REF 4-14
Table D.1 – Numeric List of Parameters (Continued)
Number Name Page