Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 140)

13-8 FlexPak 3000 DC Drive Software Reference
F00700 FACTORY DEFAULTS
RESTORED
The stored parameter values were determined to be invalid. Factory
default values have been restored. All parameter values (including any
factory set parameters) must be re-adjusted based on your application
before operating the drive. After all parameters have been set properly, a
memory save must be performed followed by a fault reset.
Possible causes:
• Power loss during a prior memory save.
• New Regulator board.
• Defective Regulator board.
F00701 FAULT LOG RESTORE
FAILURE
The fault log information stored in retentive memory was determined to be
invalid. The fault log has been cleared.
Possible causes:
• Power loss during a prior fault log save.
• Defective Regulator board.
F00702 KEYPAD REF RESTORE
FAILURE
The keypad reference value stored in retentive memory was determined to
be invalid. The keypad reference has been set to the
MINIMUM SPEED
(P.003) value.
Possible causes:
• Power loss during a previous keypad reference save.
• Defective Regulator board.
F00703 OIM KEY RESTORE
FAILURE
The OIM key states stored in retentive memory are invalid. The
FORWARD / REVERSE key has been set to FORWARD and the AUTO / MANUAL key
has been set to MANUAL .
It is possible to get this fault on a drive equipped with a DCM . If so, replace
the Regulator board.
Possible cause: Defective Regulator board.
F00800 INVALID FIELD
INSTALLED
Installed field supply is not supported by the regulator.
Possible causes:
• Disconnected, loosely connected, or damaged field supply wires.
• Regulated field supply failure.
• Regulator board failure.
F00801 FIELD FEEDBACK
OFFSET TOO HIGH
Regulated field supply feedback offset is too high.
Possible causes:
• Disconnected, loosely connected, or damaged field supply wires.
• Regulated field supply failure.
• Regulator board failure.
Table 13.1 – Fault Codes (Continued)
Code OIM Display Description