Rockwell Automation FlexPak 3000 Digital DC Drive Version 4.3 - Manual (Page 39)

Configuring the Speed Reference 4-19
AUTO MODE RAMP BYPASS (P.112)
Bypasses the speed
loop S-curve block
while in auto mode. If
the drive is in manual
mode, this parameter
has no effect and the
S-curve block cannot
be bypassed. Parameter Range: OFF
ON
Default Setting: OFF
Parameter Type: Tunable
OIM Menu Path(s): Drive Reference - Drive Reference Ramp
When AUTO RAMP BYPASS is ON and the drive is in auto mode, the speed loop ramp
function is bypassed. The bypass is automatically disabled during a ramp stop
sequence and the drive will always ramp to a stop.
!
ATTENTION: When switching from auto to manual or from manual to
auto, the drive will ramp to the reference level provided by the new source
at the rate specified by
ACCELERATION TIME (P.001) or DECELERATION TIME
(P.002). Be aware that an abrupt speed change might occur, depending
on the new reference and the rate specified in these parameters. Failure
to observe this precaution could result in bodily injury.
DECELERATION TIME (P.002)
Sets the minimum
time in which the
selected speed
reference can change
from
TOP SPEED
(P.011) to 0.
Parameter Range: 0.1 to 300.0 seconds
Default Setting: 5.0 seconds
Parameter Type: Tunable
OIM Menu Path(s): Drive Reference - Drive Reference Ramp
Quick Start
If TRIM MODE SELECT (P.110) is set to PROPORTIONAL , the actual time to decelerate
might be modified by DRAW PERCENTAGE OUT (P.196). See section 4.2, Configuring
Trim.