Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 116)

104 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 35 Profile Overrides - Virtual Interfaces Security screen
19. Define or override the following parameters from within the OSPF Settings field:
20. Select the authentication type from the Chosen Authentication Type drop-down used to
validate credentials within the OSPF dynamic route. Options include simple-password,
message-digest, null and None.
21. Select the + Add Row button at the bottom of the MD5 Authentication table to add the Key ID
and Password used for an MD5 validation of authenticator credentials.Use the spinner control
to set the OSPF message digest authentication key ID. The available range is from 1 - 255. The
password is the OSPF key either displayed as series or asterisks or in plain text (by selecting
Show).
22. Select the OK button located at the bottom right of the screen to save the changes and
overrides to the Dynamic Routing screen. Select Reset to revert to the last saved configuration.
Port Channel Override Configuration
Profile Interface Override Configuration
Priority Select this option to set the OSPF priority used to select the network designated route. Use the spinner
control to set the value from 1 - 255.
Cost Select this option to set the cost of the OSPF interface. Use the spinner control to set the value from 1 -
65,353.
Bandwidth Set the OSPF interface bandwidth (in Kbps) from 1 - 10,000,000.