Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 138)

126 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
FIGURE 48 Profile Overrides -WAN Backhaul screen
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
6. Refer to the WAN (3G) Backhaul configuration to specify WAN card settings:
7. Define or override the following authentication parameters from within the Basic Settings field:
WAN Interface Name Displays the WAN Interface name for the WAN 3G Backhaul card.
Reset WAN Card If the WAN Card becomes unresponsive or is experiencing other errors click the Reset WAN Card button
to power cycle and reboot the WAN card.
Enable WAN (3G) Check this box to enable 3G WAN card support on the device. A supported 3G card must be connected
to the device for this feature to work properly.
Username Provide a username for authentication support by the cellular data carrier.
Password Provide a password for authentication support by the cellular data carrier.
Access Point Name
(APN) Enter the name of the cellular data provider if necessary. This setting is needed in areas with multiple
cellular data providers using the same protocols, such as Europe and Asia.
Authentication Type Use the drop-down menu to specify the authentication type used by the cellular data provider.
Supported authentication types are None, PAP, CHAP, MSCHAP, and MSCHAP-v2.