Brocade Mobility RFS Controller System Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 88)

76 Brocade Mobility RFS Controller System Reference Guide
53-1003099-01
5
20. Select OK to save the changes and overrides. Selecting Reset reverts the screen to its last
saved configuration.
21. Select the Override VLAN tab to review any VLAN assignment overrides that may have been or
optionally add or edit override configurations.
FIGURE 21 WLAN Override screen - Override VLAN tab
The Override VLANs tab displays the VLANs assigned to the WLAN on the Access Point. Select
Add to create a new client limit configuration for a specific WLAN and VLAN or Edit to modify an
existing configuration.
22. Optionally define a VLAN’s wireless client limit override configuration.
NOTE
A blue override icon (to the left of a parameter) defines the parameter as having an override applied.
To remove an override go to the Basic Configuration section of the device and click the Clear
Overrides button. This removes all overrides from the device.
23. Select OK to save the changes and overrides. Selecting Reset reverts the screen to its last
saved configuration.
VLANS Use the spinner control to set a virtual interface ID (between 1 - 4094).
Wireless Client Limit Use the spinner control to set the number of users permitted on the VLAN. Set the
value to 0 to have an unlimited number of users.